Global Home You are here:Support > containsBusiness & Professional > containsOffice Products > containsNetwork Camera > containsTechnical Information > containsSetup procedure IPsec Tunnel mode (IPv6)


Main Contents begins from here.

Support

Network Camera

Setup procedure IPsec Tunnel mode (IPv6)

Setup Example of Tunnel de about IPsec

*The followings show setup examples about LAN side of the IPv6 supported router (NEC*IX1050) and the camera (KX-HCM311).

The instructions provided here explain the setup procedure on the PC (Windows XP) on an encrypted communication.

Network Configuration
Network Configuration

* Setup of router1 and 2 ( Setup of WAN side)
Refer to the operating instructions of the equipment because the setup at WAN side depends upon the equipment.

* Setup of PC1
Setup of IPsec is not required in case of Tunnel mode.

Setup of camera (BB-HCM311)

Refer to the operating instructions of the equipment because the setup at WAN side depends upon the equipment.
  1. Click [Setup] and the following screen is displayed by clicking [IPsec] on left-side menu.
    <Setup page for IPsec>

    IPsec setting

  2. Click [Add] to display the following screen.
    <Screen to set IPsec Tunnel.>

    Tunnel setting

  3. Click [Save] after setting the above items.

    3-1 : Pre-shared Key
    Enter the pre-shared key of IKE.
    Enter the pre-shared key which is set for "ROUTER1" to set IPsec Tunnel.

    3-2 : Network address
    Enter the network address at the PC side.
    *The followings are setup examples in case of Figure1.
    IPv4: 192.168.0.0/24
    IPv6: 2001:380:5003::0/64

    3-3 : The address of the router
    Enter the IP address of the router at the camera side.
    *The followings are setup examples in case of Figure1.
    IPv4: 100.100.100.1

  4. Click [Cancel] to continue setup.
    <The screen after completion of IPsec setup>

    Success!

  5. Set only [IPsec] in check box and click [Save].

    Save

  6. Click [Restart].
    *Communication with IPsec Tunnel mode after restarting the camera.

    Restart

Setup of Router1 (Setup of LAN)

Login by the other PC using Telnet and execute the setting by entering the command.

  1. Login NEC IX1050 by the other PC using Telnet and enter the following command.
    The state that the command is entered.

    ike proposal ike-prop encryption 3des hash sha group 1024-bit lifetime 300
    ike policy ike-policy peer 2001:300:e85b::280:f0ff:fe33:160 key test-ipv6-test ike-prop
    ike local-id ike-policy address fe80::20b:4fff:fea4:ff52
    ike remote-id ike-policy address 2001:300:e85b::280:f0ff:fe33:160
    ipsec autokey-proposal ipsec-prop esp-3des esp-sha lifetime time 300
    ipsec autokey-map auto1 list1 peer 2001:300:e85b::280:f0ff:fe33:160 ipsec-prop pfs 1024-bit
    ipsec local-id auto1 2001:380:5003::0/64
    ipsec remote-id auto1 2001:300:e85b::280:f0ff:fe33:160

  • Microsoft and Windows XP are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries.

Banner area begins from here.

Global Home You are here:Support > containsBusiness & Professional > containsOffice Products > containsNetwork Camera > containsTechnical Information > containsSetup procedure IPsec Tunnel mode (IPv6)