Main Contents begins from here.

Support

Network Camera

Linksys WRT54G

You selected Linksys WRT54G.

Follow the steps below and configure the router.

Step1:

Open the router's configuration web page by typing the following address on your web browser or just click the link.

http://192.168.1.1

This is the factory default local IP address for this router. If you have changed the router's local IP address, please enter proper IP address.

You can also check the router's IP address on the Network Camera's Web Page at [Maintenance] -> [Status]. It is shown as "Default Gateway" IP address.

A password request screen appears. Type the User Name and Password and click [OK] to login.

*The default settings are
User Name: (not required)
Password : admin
If you have changed the router's User Name and Password, please input the proper one.

The router configuration page appears.

Configuration image:Click [Administration] on the menu.

Click [Administration] on the menu.

Step2:

Configuration image:Choose [Enable] for UPnP and Click [Save Settings].

Choose [Enable] for "UPnP" and Click [Save Settings].

The new setting is saved and the window below appears.

Settings are successful

Click [Continue] and finish the router setup.
Now your router's UPnP is turned on.

Step3:

Please try Network Camera [Automatic Setup] procedure again.

If you need more information about this router, please read the router's manual or refer to manufacturer's Web site.

Banner area begins from here.