|Projector type||1-Chip DLP™ projector|
|Panel size||16.5 mm (0.65 in) diagonal (16:9 aspect ratio)|
|Display method||DLP™ chip x 1, DLP™ projection system|
|Number of pixels1||1920 x 1080 pixels
(If a signal other than 120 Hz/240 Hz is input, it cannot be displayed at this resolution.)
|Light source||Laser diodes|
|Light output2, 3||6,000 lm / 6,200 lm (Center)4||5,200 lm / 5,400 lm (Center)4|
|Time until light output declines to 50 %5||20,000 hours (NORMAL/QUIET)/24,000 hours (ECO)|
|Resolution||4K (3840 x 2160 pixels) (With Quad Pixel Drive)|
|Contrast ratio2||20,000:1 (Full On/Full Off)
(When [PICTURE MODE] is set to [DYNAMIC] and [DYNAMIC CONTRAST] is set to . HDMI signal input)
|Screen size (diagonal)||1.02–7.62 m (40–300 in), 16:9 aspect ratio|
|Center-to-corner zone ratio2||90 %|
|Lens||2.0x manual zoom (throw ratio: 1.46–2.93:1), manual focus, F 2.0–3.4, f 21.5–43.0 mm|
(From the origin point of the lens mounter)
|Vertical||+71 %, -48 % (manual)|
|Horizontal||+34 %, -27 % (manual)|
|Keystone correction range||Vertical: ±40 °, Horizontal: ±20 °|
|Installation||Ceiling/floor, front/rear, free 360-degree installation|
|HDMI IN 1/2||HDMI 19-pin x 2 (Compatible with HDCP 2.3, Deep Color, 4K/60p signal input6), CEC supported|
|COMPUTER IN||D-sub HD 15-pin (female) x 1 (RGB/YPBPR/YCBCR)|
|MONITOR OUT||D-sub HD 15-pin (female) x 1 (RGB/YPBPR/YCBCR)|
|AUDIO IN/OUT||M3 stereo mini-jack x 2|
|SERIAL IN||D-sub 9-pin (female) x 1 for external control (RS-232C compliant)|
|DIGITAL LINK/LAN||RJ-45 x 1 for network and DIGITAL LINK connection (video/network/serial control) (HDBaseT™ compliant), 100Base-TX (Compatible with PJLink™ [Class 2], Art-Net, HDCP 2.3, Deep Color, 4K/60p signal Input7, Extron XTP®)|
|LAN||RJ-45 x 1 for network connection, 10Base-T, 100Base-TX (Compatible with PJLink™ [Class 2], Art-Net)|
|USB||USB connector (Type A) x 1 for optional AJ-WM50 Series Wireless Module, for USB memory,
and for power supply (DC 5 V, maximum 2 A)
|Supported Internet Protocol Versions||IPv4, IPv68|
|Power supply||AC 100–240 V, 50/60 Hz,
AC 110 V, 60 Hz (Taiwan)
|Power consumption||505 W (5.5–2.4 A) (525 VA)||480 W (5.0–2.2 A) (500 VA)|
|Cabinet materials||Molded plastic|
|Operation noise2||36 dB (NORMAL/ECO) / 31 dB (QUIET)||35 dB (NORMAL/ECO) / 28 dB (QUIET)|
(W x H x D)9
|498 x 168 x 492 mm (19 5/8˝ x 6 5/8˝ x 19 3/8˝ )|
|Weight10||Approx. 16.4 kg (36.2 lbs)||Approx. 16.1 kg (35.5 lbs)|
|Operating environment||Operating temperature: 0–45 °C (32–113 °F11), operating humidity: 10–80 % (no condensation)|
|Applicable software||Logo Transfer Software, Multi Monitoring & Control Software, Early Warning Software, Projector Network Setup Software|
|Control Function via LAN||Crestron Connected™ V2, Crestron XiO Cloud™12, Art-Net DMX, AMX® DD, and PJLink™ (Class 2)|
|Terminals PT-FRQ60 Series|
1 If a signal other than 120 Hz/240 Hz is input, it cannot be displayed at this resolution.
2 Measurement, measuring conditions, and method of notation all comply with ISO/IEC 21118: 2020 international standards. Value is average of all products when shipped.
3 When [PICTURE MODE] is set to [DYNAMIC] and [LIGHT POWER] is set to [NORMAL].
4 Average light-output value of all shipped products measured at center of screen in NORMAL Mode.
5 Around this time, light output will have decreased to approximately 50 % of its original level ([PICTURE MODE]: [DYNAMIC], [DYNAMIC CONTRAST] set to , temperature 30 °C [86 °F], elevation 700 m [2,297 ft] with 0.15 mg/m3 of particulate matter). Estimated time until light output declines to 50 % varies depending on environment.
6 4K/60p signals are converted to the projector's resolution upon projection.
7 4K/60p signals are converted to projector’s resolution. Supports YPBPR 4:2:0 format only.
8 Main firmware version must be 3.00 or higher. Optional AJ-WM50 Series Wireless Module is not compatible with IPv6.
9 With legs fully retracted.
10 Average value. May differ depending on the actual unit.
11 When using the projector at an altitude lower than 2,700 m (8,858 ft) above sea level, and the operating environment temperature becomes 35 °C (95 °F) or higher, the light output may be reduced to protect the projector. When optional AJ-WM50 Series Wireless Module is attached, operating temperature range becomes 0–40 °C (32–104 °F).
12 Main firmware version must be 3.00 or higher.